8976 My electric appliance does not start, what should I do?Some of our AC electric appliances (e.g. blow-vacs and chain saws) are equipped with a safety device. Read your owner''s operating manual to check the start procedure:
* on chain saws, the chain brake must be off;
* on blow-vacs, the bag and the tubes must be fitted in order to start up
Check the power available on the socket and the condition of the fuses and the circuit-breaker. Check that the power available is the same as that required to operate the appliance (refer to the owner''s operating manual). Check that the electrical connections and the power supply cable are in good condition and not contaminated by moisture or water. If you fail to locate the problem on the electrical installation, do not open your appliance yourself: take it to an approved repairer for checking.10608 What has to be observed when applying the planer to the workpiece?Ensure that the base of the planer is applied to the work surface to ensure there is no dent cut into the work surface. It is a good idea to practice a few times before using the planer.10712 What has to be observed when taking the planer off the workpiece?When taking the planer off the work surface ensure it has fully stopped before putting it down on a surface. Planers have a blade guard however be sure it is working properly. When the planer is taken off the planed material the operator pressure must be applied to the rear of the planer base, otherwise the result will be a dent in the surface. Practice makes perfect.11180 What has to be observed when applying the planer to the workpiece?Ensure that the base of the planer is applied to the work surface to ensure there is no dent cut into the work surface. It is a good idea to practice a few times before using the planer.11284 What has to be observed when taking the planer off the workpiece?When taking the planer off the work surface ensure it has fully stopped before putting it down on a surface. Planers have a blade guard however be sure it is working properly. When the planer is taken off the planed material the operator pressure must be applied to the rear of the planer base, otherwise the result will be a dent in the surface. Practice makes perfect.11388 In which direction do you have to plane? Ensure that the planer does not cut against the emerging fibres since this would damage the surface quality. By setting the planer on at a slight angle to the feed direction one can produce an “oblique drawing cut” which improves the surface quality.12116 What do I need to do before using any tool for the first time?I need to learn about my tool and read carefully the user manual. I need to start to use it when I understood every function.15056 When I plug in my tool the circuit breaker trips or the fuse blows, what should I do?Check that the rating of the fuse and or the circuit-breaker is sufficent to operate the tool (refer to the owner''s operating manual). Check that the electrical connections and the power supply cable are in good condition ( not shorting ). If you fail to locate a problem on the electrical installation or the tool take it to an approved repairer for checking. Do not open it yourself to attemp a repair15732 My electric appliance does not start, what should I do?Some of our AC electric appliances (e.g. blow-vacs and chain saws) are equipped with a safety device. Read your owner''s operating manual to check the start procedure:
* on chain saws, the chain brake must be off;
* on blow-vacs, the bag and the tubes must be fitted in order to start up
Check the power available on the socket and the condition of the fuses and the circuit-breaker. Check that the power available is the same as that required to operate the appliance (refer to the owner''s operating manual). Check that the electrical connections and the power supply cable are in good condition and that there is no humidity. If you fail to locate a problem on the electrical installation, do not open your appliance yourself: take it to an approved repairer for checking.
Position
|
Description (Qty)
|
Part number
|
Position
|
Description (Qty)
|
Part number
|
|